Electronics » Motion Control Modules » Tic Stepper Motor Controllers »
Tic 36v4 USB Multi-Interface High-Power Stepper Motor Controller
The Tic 36v4 USB Multi-Interface High-Power Stepper Motor Controller makes basic control of a stepper motor easy, with quick configuration over USB using our free software. The controller supports six control interfaces: USB, TTL serial, I²C, analog voltage (potentiometer), quadrature encoder, and hobby radio control (RC). This version incorporates a discrete MOSFET stepper motor driver, and male headers and terminal blocks are included but not soldered. It can operate from 8 V to 50 V and can deliver up to approximately 4 A per phase without a heat sink or forced air flow (or 6 A max with sufficient additional cooling).
Alternatives available with variations in these parameter(s): model connectors soldered? Select variant…
| Description | Specs (15) | Pictures (10) | Resources (16) | FAQs (1) | On the blog (1) |
|---|
Dimensions
| Size: | 1.50″ × 1.05″ × 0.42″1 |
|---|---|
| Weight: | 6.3 g1 |
General specifications
| Model: | Tic 36v4 |
|---|---|
| Motor driver: | discrete MOSFETs |
| Control interface: |
USB; non-inverted TTL serial; I²C; RC servo pulses; analog voltage; quadrature encoder |
| Minimum operating voltage: | 8 V |
| Maximum operating voltage: | 50 V2 |
| Continuous current per phase: | 4 A3 |
| Maximum current per phase: | 6 A4 |
| Maximum step rate: | 50000 PPS |
| Microstep resolutions: | full, 1/2, 1/4, 1/8, 1/16, 1/32, 1/64, 1/128, and 1/256 |
| Reverse voltage protection?: | Y5 |
| Connectors soldered?: | N |
Identifying markings
| PCB dev codes: | tic06a |
|---|---|
| Other PCB markings: | 0J12451 |
Notes:
Related products
Home | Forum | Blog | Support | Ordering Information | Wish Lists | Distributors | BIG Order Form | About | Contact
© 2001–2023 Pololu Corporation
