Motion Control Modules » Stepper Motor Drivers » STSPIN220 Low-Voltage Stepper Motor Driver Carriers »
STSPIN220 Low-Voltage Stepper Motor Driver Carrier
This breakout board for STMicro’s STSPIN220 low-voltage microstepping bipolar stepper motor driver offers microstepping down to 1/256-step and operates from 1.8 V to 10 V, allowing stepper motors to be powered with voltages that are too low for other drivers. It can deliver up to approximately 1.1 A per phase continuously without a heat sink or forced air flow (up to 1.3 A peak). The module has a pinout and interface that are very similar to that of our popular A4988 carriers, so it can be used as a drop-in replacement for those boards in many applications.
Alternatives available with variations in these parameter(s): header pins soldered? Select variant…
Compare all products in STSPIN220 Low-Voltage Stepper Motor Driver Carriers or 16-pin Stepper Motor Drivers.
Description | Specs (15) | Pictures (8) | Resources (7) | FAQs (3) | On the blog (1) |
---|
File downloads
-
STSPIN220 datasheet (1MB pdf)
-
Schematic diagram of the STSPIN220 Stepper Motor Driver Carrier (111k pdf)
-
Dimension diagram of the STSPIN220 Stepper Motor Driver Carrier (326k pdf)
-
3D model of the STSPIN220 Stepper Motor Driver Carrier (5MB step)
-
Drill guide for the STSPIN220 Stepper Motor Driver Carrier (37k dxf)
This DXF drawing shows the locations of all of the board’s holes.
-
AN4923 application note for the STSPIN220: step-mode selection and on-the-fly switching to full-step (414k pdf)
The STSPIN220’s integrated sequencer can provide a resolution up to 256 microsteps, but it is always possible to switch to the full-step operation on-the-fly. This document describes how to select the step resolution and manage the switch between the microstep and full-step operation.
Recommended links
-
STSPIN220 documentation and resources
STMicro’s product page for the STSPIN220 low-voltage stepper motor driver, with links to its most up-to-date datasheet and other resources.