Pololu Blog » Engage Your Brain »
Mycronic MY600 solder paste jet printer first print
Installation of our new Mycronic MY600 that arrived earlier this month is going smoothly. Here are a few pictures and a video from our first test print on a Pololu PCB panel.
 |
Ninoos from Mycronic showing us how to use the MY600 solder paste jet printer. |
|---|
 |
First Pololu test panel in our new Mycronic MY600 solder paste jet printer. |
|---|
 |
The gantry is supported only on the left side! |
|---|
 |
First print on a Pololu PCB panel using Mycronic MY600 solder paste jet printer. |
|---|
 |
MY600 jet printer first print: Looks like we need a little more solder paste under the central chip and a little less on the leads. |
|---|
That footage of the jet printer in action is not sped up!
-
Save on all active Pololu-brand products, now through Tuesday
- 25 May 2018Over the next few days, we’re welcoming summer by discounting all active Pololu-brand products, which is almost everything we make. If you’re...
-
Now available: VL53L1X library for Arduino
- 6 June 2018We’ve released a basic VL53L1X library for Arduino to make it easier to get started using an ST VL53L1X time-of-flight distance sensor with an...
0 comments
Post a comment
Home | Forum | Blog | Support | Ordering Information | Wish Lists | Distributors | BIG Order Form | About | Contact
© 2001–2023 Pololu Corporation
